2.0 Mb DTI/PRI Administration and Maintenance Guide Book ... - Home

Appendix B — Basic and Network Alternate Route Selection (BARS/NARS) Page 1503 of 1536
Step 6: Gather BARS translation data. Access LD90
REQ NEW, CHG, OUT Create, change, or remove data
DMI 1-255 Digit manipulation table index
DENY x...x Number to be denied within the
HNPA, NPA, NXX, SPN, or SDRR
LDID x...x Local DID number recognized within
the HNPA, NPA, NXX, or SPN. The
maximum number of digits allowed is
10-m (11-m for 1 + dialing).
LDDD x...x Local DDD number recognized within
the HNPA, NPA, NXX, or SPN. The
maximum number of digits allowed is
10-m (11-m for 1 + dialing).
DID x...x Remote DID number recognized
within the HNPA, NPA, NXX, or SPN.
The maximum number of digits
allowed is 10-m (11-m for 1 + dialing).
DDD x...x Remote DDD number recognized
within the HNPA, NPA, NXX, or SPN.
The maximum number of digits
allowed is 10-m (11-m for 1 + dialing).
ITED x...x Incoming trunk group exclusion codes
for HNPA, NPA, NXX, or SPN. The
maximum number of digits allowed is
7-m.
ITEI x...x Incoming trunk group exclusion index
Legend:
m = the number of digits entered for the prompt NPA
X = a command used to clear a recognized xxx code
= A return after each subprompt takes you back to SDRR
The following prompts appear if TYPE is SPN:
Option 11C 2.0 Mb DTI/PRI Administration and Maintenance guide