2.0 Mb DTI/PRI Administration and Maintenance Guide Book ... - Home

Chapter 13 — ISDN Feature Implementation Page 1167 of 1536
AC1: This specifies Access Code 1. Enter the 1- to 4-digit network access
code at this prompt.
AC2: This specifies Access Code 2. Enter the 1- to 4-digit network access
code at this prompt.
Respond to the following prompts in overlay 87.
DMI: This specifies the Digit Manipulation Index. Respond to this prompt
with the index number, from 0 to 999.
RLI: This specifies the Route List Index to be accessed. It must be set
separately for the distant steering code and trunk steering code (under
TYPE=DSC and TYPE=TSC respectively). Respond to this prompt with the
index number, from 0 to 999.
FLEN: This specifies the length (flexible) of digits to be expected. Respond
to this prompt with the expected digit length, from 0 to 16 for Trunk Steering
Code, and from 0 to 10 for Distant Steering Code. (The default is 0.)
DSP: This specifies that either the Local Steering Code (LSC), Home
Location Code (HLOC) or Directory Number (DN) is to be used for the
Calling Station ID, in Group Dialing Plan calls. Respond to this prompt with
either LSC, LOC or DN.
FSNS: This specifies the Free Special Number Screening Index (prompted
under TYPE=FSNS). Respond to this prompt with the index number, from 1
to 255.
SPN: This specifies the special-number code to be screened. Respond to this
prompt with the 1- to 11-digit code to be used.
XXX: This specifies whether routing codes are to be denied or allowed.
Respond to this prompt with either DENY to deny these codes, or ALOW to
allow them.
DENY: This is prompted if the XXX prompt is set to DENY. Respond to it
with the routing codes or range of routing codes to be denied.
ALOW: This is prompted if the XXX prompt is set to ALOW. Respond to
it with the routing codes or range of routing codes to be allowed.
Option 11C 2.0 Mb DTI/PRI Administration and Maintenance guide