2.0 Mb DTI/PRI Administration and Maintenance Guide Book ... - Home

- CLID OPT0
- PROG
...
OPT1
OPT2
OPT3
OPT4
OPT5
NCHG
MALE
MCON
- RCAP COLP
XCOL
...
Chapter 13 — ISDN Feature Implementation Page 1189 of 1536
Prefix = 0, for North American dialing plan. This is the
default value for ESIG and ISIG interfaces.
Prefix = 1, for international PFXs in CLID, any numbering
type supported. This is the default value for all EuroISDN
interfaces.
Prefix = 2, for international PFXs in CLID, CCITT
numbering type supported: UKWN, INTL, NPA, and NXX.
Default value for CO/DID routes for the Telecom New
Zealand interface.
Prefix = 3, for international PFXs in CLID, only NXX number
type supported. Default value for TIE routes for the
Telecom New Zealand interface.
For international COs, if the call originates from a CO trunk
type, add nothing. Otherwise, add PFX1 and PFX2. This is
the default value for the Hong Kong, Singapore, and
Thailand interfaces.
This is the same as OPT4, except it supports a maximum of
10 digits in the CLID. This is the default value for the
Austrian interface.
Progress Signal.
Send PROGRESS (default value for all interfaces, except
Austria).
Send ALERT after CALL PROCEEDING.
Send CONNECT after CALL PROCEEDING (this is the
default value for the Austrian interface).
Enter COLP to support Connected Line Identification
Presentation as a remote capability. This is the default
value for the ESIG, ISIG, NI2, and EURO interfaces.
Enter XCOL to remove Connect Line Identification
Presentation as a remote capability. This is the default
value for the APAC, AUS, EIR, DEUT, ESP, BEL, and FRA
interfaces.
Option 11C 2.0 Mb DTI/PRI Administration and Maintenance guide