2.0 Mb DTI/PRI Administration and Maintenance Guide Book ... - Home

Page 1088 of 1536 Chapter 13 — ISDN Feature Implementation
Call Charging under 1 TR 6 Connections
In overlay 12:
— For nodes with 1 TR 6 connections, respond to the TYPE prompt with
ATT. Respond to the KEY prompt with 0-9 MTR for each attendant
console to have a Meter key. (Respond with 0-9 NULL to remove a
Meter key.)
In overlay 15:
— Respond to the ISDN prompt with YES. This gives rise to the PFX1 and
PFX2 prompts. Respond to these with Prefix 1 and Prefix 2 respectively
(each a maximum of four digits). This information is sent out as part of
the Call Setup message.
For nodes with 1 TR 6 connections, call charging and charge recording
must be configured in overlay 15:
— Respond to the ICI prompt with xxMTR to assign a meter recall key on
an ICI position at attendant consoles.
— Respond to the PPMD prompt with YES to enter periodic pulse metering
(PPM) data, or NO to continue without being prompted for PPM data. If
you are entering PPM data, respond to the HMTL prompt with YES to
select the Hotel/Motel option, or NO to suppress this option. Respond to
the PCDL prompt with YES to generate call charging information in the
CDR Link tape records, or NO to suppress this option. Define the call
charge unit cost by responding to the UCST prompt with a value from 1
to 9999. (Entering a value of 0 disables this option.) Respond to the
ATCH prompt with YES to display call charge information on the
attendant console, or NO to prevent display.
553-3011-315 Standard 10.0 May 1999