2.0 Mb DTI/PRI Administration and Maintenance Guide Book ... - Home

Page 1178 of 1536 Chapter 13 — ISDN Feature Implementation
- TIMR (NO) YES Change protocol timer value.
- - T310 10-60 Timer used to determine how long the switch can wait for
the response message when the QSIG outgoing call is in
the outgoing call processing state.
- - INC_T306 0,(2),...,T306
(T306 is the duration
of the T306 Network
timer in seconds)
--OUT_T3060,2,...,(T306) (T306 is the duration
of the T306 Network
timer in seconds)
553-3011-315 Standard 10.0 May 1999
Variable timer for received DISCONNECT message on
incoming calls, allowing in-band tone to be heard when
sent by the network. The network will stop sending tone
after T306 expires, so the maximum time will be T306.
Entered in two-second increments.
TCNZ interface: T306 = 30 sec.
Variable timer for received DISCONNECT message on
outgoing calls, allowing in-band tone to be heard when
sent by the network. The network will stop sending tone
after T306 expires, so the maximum time will be T306.
Entered in two-second increments.
TCNZ interface: T306 = 30 sec.
- LAPD (NO) YES Change the Link Access Protocol for D-channel
parameters.