2.0 Mb DTI/PRI Administration and Maintenance Guide Book ... - Home

Chapter 13 — ISDN Feature Implementation Page 1387 of 1536
LD 15 – Configure the customer CLID database (required for outgoing calls,
if ICOG = OGT in LD 16).
Prompt Response Description
REQ: NEW
CHG
Add new data
Change or delete existing data.
TYPE: NET Networking data (if REQ = CHG only.)
CUST xx Customer number.
xx = 0-99 for Options 51C-81/81C
xx = 0-31 for Option 11C.
...
- CLID (NO) YES CLID option.
YES = configure a CLID table for the customer.
NO = do not configure a CLID table. In this case, the
remaining prompts are not generated, and no CLID is sent
for the customer.
- - SIZE 0-(256)-4000 The maximum number of CLID entries needed for a
customer.
If REQ = NEW, you may select the default value (256) by
entering in response to this prompt.
It is advised that you not define a size much larger than
actually needed. This entry may be increased or decreased
as required.
- - INTL 0-9999
X
- - ENTRY aaaa
Xaaaa
Xaaaa Xbbbb
Country code, for international number.
Enter X to delete the digits.
CLID entry to be configured.
CLID entry to be deleted.
Range of CLID entries to be deleted, aaaa and bbbb must
be a value between 0 and (SIZE-1).
The ENTRY prompt is repeated until is entered as a
response.
Option 11C 2.0 Mb DTI/PRI Administration and Maintenance guide