2.0 Mb DTI/PRI Administration and Maintenance Guide Book ... - Home

Chapter 3 — DPNSS1/DASS2 features description and implementation Page 745 of 1536
— LD15- Configure the Multi-party Operation attributes.
• In response to the MPO prompt, enter YES.
• In response to the CCDO prompt, enter YES/NO to allow/deny
transfer after inquiry.
• In response to the RALL prompt, enter YES/NO to allow/deny
mandatory recall.
• In response to the CDTO prompt, enter a value from 2-(14) to define
the control digit for time out.
• In response to the IFLS prompt, enter YES/NO to ignore/allow a
switch-hook flash operation.
• In response to the MHLD prompt, enter YES/NO to indicate
whether or not manual hold is required.
• In response to the PCDS prompt, enter YES/NO to allow/deny the
entering of control digits.
• In response to the CNFD prompt, enter a value from 0-(1)-9, or # or
*, to define the control digit for conference.
• In response to the TGLD prompt, enter a value from 0-(2)-9, or # or
*, to define the control digit for toggle.
• In response to the DISD prompt, enter a value from 0-(3)-9, or # or
*, to define the control digit for disconnect.
• In response to the FMPO prompt, enter YES to define flexible
misoperation treatments for Multi-party Operation.
• In response to the AOCS prompt, enter XXXX (treatment for
internal calls) and YYYY (treatment for external calls), where
XXXX and YYYY may be ATN (route to attendant), DAR
(disconnect after re-ring cycle of 1-15), AAR (route to attendant
after re-ring cycle), OVF (overflow tone), DIS (disconnect), or STD
(standard operation, which is disconnect for internal and route to
attendant for external).
Option 11C 2.0 Mb DTI/PRI Administration and Maintenance guide