2.0 Mb DTI/PRI Administration and Maintenance Guide Book ... - Home

- PROG
...
NCHG
MALE
MCON
- RCAP aaaa
Xaaaa
...
Chapter 13 — ISDN Feature Implementation Page 1153 of 1536
Progress Signal.
Send PROGRESS (default value for all interfaces, except
Austria).
Send ALERT after CALL PROCEEDING.
Send CONNNECT after CALL PROCEEDING (this is the
default value for the Austrian interface).
Remote capabilities.
Precede with an X to remove an existing configuration.
- CPFXS (YES) NO Customer-defined Prefixes option. This prompt is added as
one of the sub-prompts of ISDN = YES. It is added at the
end of the ISDN sub-prompts.
If CPFXS = YES, when constructing the Calling or
Connected Line Identification, the prefixes are retrieved
from the Customer Data Block via the PFX1 and PFX2
prompts in LD 15, as is currently done. This is the default
response.
If CPFXS = NO, when constructing the Calling or
Connected Line Identification, the prefixes are retrieved
from the Route Data Block via the HNTN and HLCL
prompts in LD 16.
- - HNTN 0-9999 Home National Number. This number is similar to the PFX1
number prompted in LD 15. It is added to this overlay so
that this prefix can be configured on a route basis as
required in some countries (e.g., Italy). As is the case with
PFX1, the HNTN prefix can be from one-to-four digits long.
This prompt is displayed only if CPFXS = NO.
If only a is entered, this prompt keeps its previous
configuration. If no value was configured previously, no
value will be configured.
Enter X to delete the digits.
Option 11C 2.0 Mb DTI/PRI Administration and Maintenance guide