2.0 Mb DTI/PRI Administration and Maintenance Guide Book ... - Home

Page 1294 of 1536 Chapter 13 — ISDN Feature Implementation
Establish data interface process at the ISPC SLAVE side of an ISPC link at
loop (l) and channel (ch), where “N” = the “number of tries” counter. The
actual range of N = 0-(1)-255.
When N = 0, the mode is set to AUTOMATIC. This mode requires one TDS
slot and one DTR unit. This mode is not recommended for use on small
systems or systems loaded with heavy traffic.
When N > 0, the process is activated for a period of up to N * 30 minutes.
The available range goes from 30 minutes (N = 1) to 128.5 hours or 5 days
(N = 255).
If no value is entered for N, it defaults to a value of 1. When N = 1, one
attempt will be made to establish the data interface process before the
ISPC slave D-channel is released.
RLS ISPC l ch Stop the data interface establishment process.
When this command is entered, the mode becomes MANUAL and the
number of attempts to be performed = 0.
553-3011-315 Standard 10.0 May 1999