Technical Information

KM-LOC Clamping Units (continued)
The KM-LOC
Under normal use, the KM-LOC unit is designed to last 50,000 cycles.
The KM-LOC units are greased at the factory during assembly. To keep the
unit functioning properly, it should be periodically greased and, if operating
under normal conditions, done regularly every six months.
How to Grease the KM-LOC
Remove the M6 sealing screw from the front face of the lockrod and thread the
grease fitting into the tapped hole. A grease fitting is in the spare parts package
included with every KM-LOC clamping unit.
Approximate grease amounts are as follows:
KM32 ..............0.2–0.3 fl. oz
KM40 ..............0.3–0.4 fl. oz.
KM50 ..............0.5–0.6 fl .oz.
KM63 ..............0.5–0.6 fl. oz.
Kennametal uses and recommends GLEITMO 805, a white,
high-performance grease paste.
KM-LOC Mounting Wedges • Tightening Torque
NOTE: Use a hex bit socket.
www.kennametal.com
Technical Information
KM-LOC Clamping System
order
lubricant
number size
GLEITMO 805 grease 1567575 500g cartridge
GLEITMO 805 grease 1567577 1000g tin
catalog
number
wedge screw
hex size ft. lbs. Nm
KM32CLSR/L2050K 4mm 10–14 14–18
KM32CLSR/L1250B 4mm 10–14 14–18
KM32CLSR/L1250C 4mm 10–14 14–18
KM32CLSR/L1650C 4mm 10–14 14–18
M31
Technical Information