You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Operating Conditions • KM50TS • Inch<br />
Chart 5<br />
F<br />
(inch)<br />
Chart 6<br />
doc<br />
(inch)<br />
10.0<br />
8.0<br />
6.0<br />
4.0<br />
2.0<br />
www.kennametal.com<br />
F and L1 Dimensions (inch) vs. Tangential Loads (lbs)<br />
for KM50TS<br />
0<br />
0 1.0 2.0 3.0 4.0 5.0 6.0 7.0 8.0 9.0 10.0<br />
L1 (inch)<br />
Depth of Cut (inch) and Feed Rate (IPR) vs. Tangential Forces (lbs)<br />
for KM50TS<br />
feed rate (IPR)<br />
<strong>Technical</strong> <strong>Information</strong><br />
KM Application Data<br />
IMPORTANT<br />
<strong>Information</strong> shown on the following charts was developed exclusively for use with KM tooling in static conditions. Do not use for any other tooling<br />
system because the results will not apply. To account for cutting force fluctuations in dynamic conditions, a reduction of 20–30% should be applied<br />
to the loads shown in charts.<br />
0.60<br />
0.50<br />
0.40<br />
0.30<br />
0.20<br />
0.10<br />
0<br />
3000<br />
3800<br />
2300<br />
1900<br />
1600<br />
1400<br />
1900<br />
1600<br />
1400<br />
1200<br />
900<br />
0 0.005 0.010 0.015 0.020 0.025 0.030 0.035 0.040 0.045 0.050<br />
1200<br />
2300<br />
900<br />
3000<br />
3800<br />
M45<br />
<strong>Technical</strong> <strong>Information</strong>
Change language