Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Operating Conditions • KM40TS • Inch<br />
Chart 3<br />
F<br />
(inch)<br />
Chart 4<br />
doc<br />
(inch)<br />
5.5<br />
4.8<br />
4.0<br />
3.2<br />
2.4<br />
1.6<br />
0.8<br />
0.45<br />
0.40<br />
0.35<br />
0.30<br />
0.25<br />
0.20<br />
0.15<br />
0.10<br />
0.05<br />
www.kennametal.com<br />
F and L1 Dimensions (inch) vs. Tangential Loads (lbs)<br />
for KM40TS<br />
0<br />
0 1.0 2.0 3.0<br />
L1 (inch)<br />
4.0 5.0 6.0<br />
0<br />
1100<br />
Depth of Cut (inch) and Feed Rate (IPR) vs. Tangential Forces (lbs)<br />
for KM40TS<br />
900<br />
feed rate (ipr)<br />
<strong>Technical</strong> <strong>Information</strong><br />
KM Application Data<br />
IMPORTANT<br />
<strong>Information</strong> shown on the following charts was developed exclusively for use with KM tooling in static conditions. Do not use for any other tooling<br />
system because the results will not apply. To account for cutting force fluctuations in dynamic conditions, a reduction of 20–30% should be applied<br />
to the loads shown in charts.<br />
1350<br />
1600<br />
1800<br />
2000<br />
700<br />
750<br />
900<br />
0 0.005 0.010 0.015 0.020 0.025 0.030 0.035 0.040<br />
1100<br />
750<br />
700<br />
1600<br />
1350<br />
2000<br />
1800<br />
M43<br />
<strong>Technical</strong> <strong>Information</strong>
Change language