Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Operating Conditions • KM63TS and KM63XMZ • Inch<br />
Chart 7<br />
F<br />
(inch)<br />
Chart 8<br />
doc<br />
(inch)<br />
16.0<br />
14.0<br />
12.0<br />
10.0<br />
8.0<br />
6.0<br />
4.0<br />
2.0<br />
www.kennametal.com<br />
0<br />
0.80<br />
0.70<br />
0.60<br />
0.50<br />
0.40<br />
0.30<br />
0.20<br />
0.10<br />
0<br />
F and L1 Dimensions (inch) vs. Tangential Loads (lbs)<br />
for KM63TS and KM63XMZ<br />
L1 (inch)<br />
Depth of Cut (inch) and Feed Rate (IPR) vs. Tangential Forces (lbs)<br />
for KM63TS and KM63XMZ<br />
feed rate (IPR)<br />
<strong>Technical</strong> <strong>Information</strong><br />
KM Application Data<br />
IMPORTANT<br />
<strong>Information</strong> shown on the following charts was developed exclusively for use with KM tooling in static conditions. Do not use for any other tooling<br />
system because the results will not apply. To account for cutting force fluctuations in dynamic conditions, a reduction of 20–30% should be applied<br />
to the loads shown in charts.<br />
6000<br />
4500<br />
3800<br />
3000<br />
2300<br />
1900<br />
0 1.5 3.0 4.5 6.0 7.5 9.0 10.5 12.0 13.5 15.0 16.5<br />
2300<br />
1900<br />
1500<br />
1200<br />
0 0.005 0.010 0.015 0.020 0.025 0.030 0.035 0.040 0.045 0.050 0.055 0.060<br />
1500<br />
3000<br />
3800<br />
4500<br />
1200<br />
6000<br />
M47<br />
<strong>Technical</strong> <strong>Information</strong>
Change language