You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Technical</strong> <strong>Information</strong><br />
<strong>Technical</strong> <strong>Information</strong><br />
KM Application Data<br />
Operating Conditions • KM63TS and KM63XMZ • Metric<br />
IMPORTANT<br />
<strong>Information</strong> shown on the following charts was developed exclusively for use with KM tooling in static conditions. Do not use for any other tooling<br />
system because the results will not apply. To account for cutting force fluctuations in dynamic conditions, a reduction of 20–30% should be applied<br />
to the loads shown in charts.<br />
Chart 7<br />
F<br />
(mm)<br />
Chart 8<br />
doc<br />
(mm)<br />
400<br />
350<br />
300<br />
250<br />
200<br />
150<br />
100<br />
50<br />
20,00<br />
17,50<br />
15,00<br />
12,50<br />
10,00<br />
7,50<br />
5,00<br />
2,50<br />
F and L1 Dimensions (mm) vs. Tangential Loads (N)<br />
for KM63TS and KM63XMZ<br />
0<br />
0 40 80 120 160 200 240 280 320 360 400 440<br />
L1 (mm)<br />
0<br />
13400<br />
16700<br />
20000<br />
26700<br />
10000<br />
8400<br />
Depth of Cut (mm) and Feed Rate (mm/rev) vs. Tangential Forces (N)<br />
for KM63TS and KM63XMZ<br />
0 0,10 0,20 0,30 0,40 0,50 0,60 0,70 0,80 0,90 1,00 1,10 1,20 1,30 1,40 1,50<br />
feed rate (mm/rev)<br />
M46 www.kennametal.com<br />
6700<br />
10000<br />
8400<br />
6700<br />
5000<br />
5000<br />
20000<br />
16700<br />
13400<br />
26700