You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Technical</strong> <strong>Information</strong><br />
<strong>Technical</strong> <strong>Information</strong><br />
KM Application Data<br />
Operating Conditions • KM80TS and KM80ATC • Metric<br />
IMPORTANT<br />
<strong>Information</strong> shown on the following charts was developed exclusively for use with KM tooling in static conditions. Do not use for any other tooling<br />
system because the results will not apply. To account for cutting force fluctuations in dynamic conditions, a reduction of 20–30% should be applied<br />
to the loads shown in charts.<br />
Chart 9<br />
F<br />
(mm)<br />
Chart 10<br />
doc<br />
(mm)<br />
400<br />
350<br />
300<br />
250<br />
F and L1 Dimensions (mm) vs. Tangential Loads (N)<br />
for KM80TS and KM80ATC<br />
200<br />
9000<br />
150<br />
11500<br />
15000<br />
100<br />
19000<br />
23000<br />
50<br />
30000<br />
27000<br />
38000<br />
0<br />
0 40 80 120 160 200 240 280 320 360 400 440<br />
L1 (mm)<br />
30<br />
27<br />
24<br />
21<br />
18<br />
15<br />
12<br />
9<br />
6<br />
3<br />
0<br />
Depth of Cut (mm) and Feed Rate (mm/rev) vs. Tangential Forces (N)<br />
for KM80TS and KM80ATC<br />
27000<br />
23000<br />
19000<br />
15000<br />
11500<br />
9000<br />
0 0,25 0,50 0,75 1,00 1,25 1,50 1,75 2,00 2,25 2,50<br />
feed rate (mm/rev)<br />
M48 www.kennametal.com<br />
30000<br />
38000
Change language