INSTRUCTION MANUAL - Scorpio
INSTRUCTION MANUAL - Scorpio
INSTRUCTION MANUAL - Scorpio
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
SWITCH ASSIGNMENT TABLE<br />
<br />
below.<br />
<br />
AUX-CH.<br />
<br />
<br />
check that you have the desired switch assignment for each function during set up.<br />
Switch/VR<br />
A or H<br />
Airplane (ACRO) Helicopter (HELI)<br />
SWITCH A elevator dual rate elevator dual rate<br />
SWITCH B rudder dual rate rudder dual rate<br />
SWITCH C up = ELE-FLP on<br />
center/down = IDLE-DOWN<br />
down = AIRBRAKE on<br />
governor<br />
SWITCH D aileron dual rate aileron dual rate<br />
SWITCH E or G* landing gear/ch 5 throttle hold/ch5<br />
SWITCH F or H* snap roll/trainer trainer/THR-CUT<br />
SWITCH G or E* none idle-up 1 and 2<br />
SWITCH H or F* none idle-up3/gyro<br />
VR <br />
FLAPERON on)<br />
CH8<br />
*On the 8JA Mode 2 transmitters, the TOP LEFT SWITCHES are spring-loaded and 2-position; on the 8JA Mode 1, 8JH, those<br />
switches are on the right side. For consistency, the switch position’s designation remains the same (upper left is F, etc), but the<br />
functions are moved to match the switch type.<br />
TO TURN ON THE 8J SYSTEM<br />
First make sure the throttle stick is in the low throttle position.<br />
*If the throttle stick is not in the low position,<br />
you'll have an alarm until the stick is in the low position.<br />
13<br />
Push up to turn on.