INSTRUCTION MANUAL - Scorpio
INSTRUCTION MANUAL - Scorpio
INSTRUCTION MANUAL - Scorpio
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
TRIM submenu: resets and adjust effectiveness of digital trims.<br />
The 8J has digital trims which are different from conventional mechanical trim<br />
sliders. Each TRIM LEVER<br />
TRIM LEVER is pressed, the trim is changed a selected amount. When you<br />
hold the TRIM LEVER, the trim speed increases. The current trim position is<br />
graphically displayed on the start up screen. The TRIM submenu includes two<br />
functions that are used to manage the trim options.<br />
HELI models only: OFFSET is available in the idle ups. If OFFSET is inhibited, adjustment of the TRIM LEVERS will adjust<br />
OFFSET is active, then moving the trims within any one condition will affect only that<br />
condition. See OFFSET, p. 83.<br />
Trim reset (RESET): electronically centers the trims to their default values. Note that the SUB-TRIM settings and the trim<br />
STEP rate are not reset by this command.<br />
GOAL of EXAMPLE: STEPS: INPUTS:<br />
Reset trims to neutral after having Open TRIM submenu. for 1 second.<br />
<br />
to TRIM.<br />
Reset trims to neutral. for 1 second.<br />
Beep sounds.<br />
Close.<br />
Where next? Adjust SUB-TRIMs: see p.46.<br />
Adjust trim rate (STEP): see below.<br />
Adjust END POINTs: see p. 36.<br />
Set up dual/triple rates and exponential (D/R,EXP): see p. 39.<br />
Trim step (STEP): changes the rate at which the trim moves when the TRIM LEVER is activated. It may be set from 1 to<br />
40 units, depending on the characteristics of the aircraft. Most ordinary aircraft do well at about 2 to 10 units. Generally<br />
<br />
<br />
GOAL of EXAMPLE: STEPS: INPUTS:<br />
Double the sensitivity (larger step) of Open TRIM submenu and choose the for 1 second.<br />
the AILERON TRIM LEVERS for STEP you wish to change. (Ex: aileron)<br />
a first flight of an aerobatic model to<br />
to TRIM.<br />
Adjust<br />
the size of the step.<br />
to AIL. to 8.<br />
<br />
(Ex: incr. to 8)<br />
Repeat as desired for other channels.<br />
Close.<br />
to ELEV.<br />
Repeat as needed.<br />
to new setting.<br />
Where next? Adjust sub trims: see p. 46.<br />
Adjust END POINTs: see p. 36.<br />
Set up dual/triple rates and exponential (D/R,EXP): see p. 39.<br />
45