INSTRUCTION MANUAL - Scorpio
INSTRUCTION MANUAL - Scorpio
INSTRUCTION MANUAL - Scorpio
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
LINEAR PROGRAMMABLE MIXES (PROG.MIX1-4):<br />
Your 8J contains four separate linear programmable mixes. (Note that P.Mixing<br />
<br />
There are a variety of reasons you might want to use these mixes. A few are<br />
<br />
<br />
<br />
<br />
setup follows, step by step, to assist you.<br />
<br />
<br />
<br />
<br />
<br />
<br />
<br />
<br />
Adjustability:<br />
<br />
these mixes, simply select that mix number so that the master and slave servos are already selected for you.<br />
PROG.MIX1<br />
PROG.MIX2HELI<br />
PROG.MIX3HELI<br />
PROG.MIX4<br />
<br />
also be set to the master channels. (see below.)<br />
the controlling channel. The channel whose movement is followed by the slave channel.<br />
Another channel: <br />
coupling.)<br />
MASTER TRIM POSITION RATE <br />
RUDD AIL OFF ANY NULL 25% 0<br />
To create an OFFSET<br />
when SWITCH C is in down position.)<br />
MASTER TRIM POSITION RATE <br />
OFS FLP N/A C DOWN 20% N/A<br />
<br />
(Ex: create a second throttle trim on DT6 lever.)<br />
MASTER TRIM POSITION RATE <br />
DT6 THR N/A ANY NULL 5% N/A<br />
the controlled channel. The channel that is moved automatically in response to the movement of the master<br />
<br />
<br />
With TRIM OFF, rudder trim would bind the two servos. TRIM ON resolves this.<br />
65
Change language