INSTRUCTION MANUAL - Scorpio
INSTRUCTION MANUAL - Scorpio
INSTRUCTION MANUAL - Scorpio
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Adjustable travel limit (ATL TRIM LEVER (THROTTLE TRIM) effective only at low throttle,<br />
disabling the trim at high throttle. This prevents pushrod jamming due to idling trim changes. This function defaults to ON.<br />
If you are not using channel 3 for throttle, you may want trim operation the same as on all other channels. To do so, set ATL<br />
to OFF. If you need the ATLTHR-REV setting. Note<br />
that this affects all models in the radio, not just the model you are currently editing. THR-REV, see p. 92.<br />
GOAL of EXAMPLE: STEPS: INPUTS:<br />
Change ATL from ON to OFF for battling Open the menu, then open PARAMETER for 1 second.<br />
submenu.<br />
channel 3 uses.<br />
to PARAMETER.<br />
Go to ATL and Change. (Ex: to OFF)<br />
Close.<br />
to ATL. to OFF.<br />
Where next? Set up ELEVON<br />
Set up IDLE-DOWN and THR-CUT<br />
<br />
Utilize servo REVERSE: see p. 35.<br />
Adjust servo travel with END POINT: see p. 36.<br />
Set up dual/triple rates and exponential(D/R,EXP): see p. 39.<br />
LCD screen adjustment (CONTRAST/BACK-LIT/LIT-TIME/LIT-ADJS):<br />
Adjustability:<br />
The following LCD screen adjustments are possible.<br />
<br />
<br />
<br />
<br />
GOAL of EXAMPLE: STEPS: INPUTS:<br />
Change CONTRAST from 0 to +2. Open the menu, then open PARAMETER for 1 second.<br />
submenu.<br />
to PARAMETER.<br />
Go to CONTRAST and change setting.<br />
(Ex: +2)<br />
Close.<br />
32<br />
to CONTRAST.<br />
to +2.