INSTRUCTION MANUAL - Scorpio

GOAL of EXAMPLE: STEPS: INPUTS:
Set up a FLAP-ELEV mix:
Open an unused programmable mix. for 1 second.
(Ex: use P.MIX3
ON when SWITCH C is in the down for FLAP-ELEVATOR.)
to P.MIX1-6.
position.
to 3
Activate the function. to MIX. to ON.
up (spoilers),
Choose master and slave channels. already FLP
(Ex: no need to change MASTER/SLAVE.)
already ELE
OFS, DT5, DT6 or to
move down,
MASTER. to desired
VR
choice.
TRIM is not Set TRIM as needed.
(Ex: leave TRIM not available.)
Assign SWITCH and position.
to SW. to C.
(Ex: change to C, DOWN.)
to POSI. to DOWN.
Optional: set switch to THR to activate to SW. to THR.
THROTTLE STICK
to POSI.
THROTTLE STICK to desired
point.
Optional: set switch position to NULL
THR
Set rates. (Ex: Lo=0%5%.) to RATE.
67
for 1 second to set.
to POSI. to NULL.
VR past center. Leave at 0%.
VR past center. to 5%.
Set OFFST, if needed. (Ex: 0.) to OFFST. Leave at 0%.
Close menu.
Where next? Adjust servo END POINTs: see p. 36.
Setup dual/triple rates and exponential (D/R,EXP): see p. 39.
Set up additional programmable mixes, ex: RUDDERAILERON: see p. 65.
RUD-ELEV (ACRO) mix: Compensate for pitching up or down when rudder is applied.
AIL-RUD (ACRO): Coordinate turns by applying rudder automatically with aileron input. All model types.
ELEV-PIT (HELI) mix: compensate for the loss of lift of tilting the model.