INSTRUCTION MANUAL - Scorpio

SWASH AFR (not in SWH1):
Swashplate function rate settings (SWASH AFR) reduce/increase/reverse the rate
(travel) of the aileron, elevator (except H-2 ) and collective pitch functions,
adjusting or reversing the motion of all servos involved in that function, only
when using that function. Since these types utilize multiple servos together to
REVERSE or END POINT would not
properly correct the travel of any one control. Since H-1 uses one servo for each
H-1.
®
everything installed per factory instructions, set the model to HELI(HR3
choices left—the whole function needs to be reversed, or the servo(s) not shared with aileron need to be reversed.
direction in which the collective operates (reverse the whole function). In our example, HR3 is 180 degrees off from the
collective pitch rate, however, from +50% to -50%, will reverse the collective pitch without affecting the aileron action.
CHECKING FOR PROPER MOTION ON AN HR3 SWASHPLATE
HR3 Swash Type PROPER MOTION WRONG MOTION HOW TO FIX
AILERON STICK. Swashplate tilts right. Swashplate tilts left. Reverse AIL setting in SWASH
to -50%.
up.
REVERSE.
down.
REVERSE.
ELEVATOR STICK. Swashplate
moves the Reverse ELE setting in SWASH.
opposite.
(ex: +50 to -50)
moves up.
Entire swashplate moves up.
REVERSE.
RUDDER STICK. The leading edges of tail Blades rotated right.
blades rotate left.
REVERSE the rudder servo.
THROTTLE STICK. Entire Swashplate lifts. Swashplate lowers. Reverse PIT setting in SWASH.
GOAL of EXAMPLE: STEPS: INPUTS:
Adjust the travel of the collective pitch Open SWASH AFR function. for 1 second.
from +50% to -23%, reversing the travel
of all 3 servos and decreasing their
to SWASH AFR.
travel in collective pitch only, on an Adjust PIT travel to -23%. to PIT. to -23%.
HR3 SWASH TYPE.
Close the menu.
Where next?
END POINT: see p. 36.
Set up the normal condition: (THR-CURV/NOR, PIT-CURV/NOR, REVO./NORM):
see p. 78.
Set up D/R,EXP: see p. 39.
75