INSTRUCTION MANUAL - Scorpio

Using V-TAIL (ACRO):
V-TAIL
functions are combined for the two tail surfaces. Both elevator and rudder travel
can be adjusted independently on each surface.
NOTE: If V-TAIL is active, you cannot activate ELEVON or AILEVATOR functions. If one of these functions is active, an error
message will be displayed and you must deactivate the last function prior to activating V-TAIL.
NOTE
travel until no binding occurs.
Adjustability:
RUD1 and 2 to 0. Next, use two programmable
mixes, RUD-ELE and RUD-RUD, setting different percentages for up and down. These are your new rudder travels. Trim off
PROG.MIX, p. 65.)
GOAL of EXAMPLE: STEPS: INPUTS:
Activate V-TAIL.
Open the V-TAIL function. for 1 second.
Adjust left elevator servo to 95% travel
Activate the function.
to V-TAIL.
to MIX. to ACT.
optional: adjust the travels separately to ELE1. to 95%.
Repeat as necessary for other servos.
left to 95%
Close menu.
Where next? Adjust END POINTs: see p. 36 and SUB-TRIMs: see p. 46.
Set up dual/triple rates and exponential(D/R,EXP): see p. 39.
Set up ELE-FLAP mix: see p. 59.
55