INSTRUCTION MANUAL - Scorpio

OFFSET: Optional separate trims in addition to those for the normal condition. This function is used to automatically change
helicopter tends to drift to the right at high speeds, so an aileron offset may be applied to offset the helicopter to the left.
The necessary elevator offset varies with model geometry, so it must be determined by noting collective pitch changes at
high speed. The rudder offset is affected by both revo. mixing and trim lever movement while in the offset function.
Adjustability:
CONDITION SELECT option that creates/
OFFSET is active (its switch is on), moving the TRIM LEVERS adjusts
the stored offset, not the trims in the normal condition.
OFFSET is inactive (its switch is off), the OFFSET and any trim adjustments
condition.)
OFFSET
DELAY function.
*During OFFSET operation, the aileron, elevator, and rudder travels are displayed on each trim
display in the Startup screen.
NOTE:
GOAL of EXAMPLE: STEPS: INPUTS:
Set up separate trims for each of the Open the OFFSET function. for 1 second.
to OFFSET.
Activate
the function. to MIX. to OFF or ON.
correct for torque at high speeds. Change switch setting to Cond.
(No need to change SW.)
already Cond.
Select IDL2. to No.
second to IDL2.
to IDL2. or for 1
Adjust trim settings as needed.
(Ex:rudder to +8%.)
to RUDD. to +8%.
EG (T8JA) from
NORMAL to IDL2
changes.
Where next? DELAY: see p. 84.
THR-HOLD: see p. 80.
(THR-CURVE, PIT-CURVE, REVO. MIX
83