Vision and Studio Vision Pro Version 4.1 Manual ... - House of Synth

CHAPTER 2: Enhancements in 4.1
TDM Plug-Ins
TDM plug-ins, which are assigned in the
Console Window, offer real-time processing
of audio.
SETTINGS WINDOW
TDM support is only included with Studio
Vision Pro when using DAE. To use TDM
plug-ins you must have TDM-compatible
Digidesign hardware.
For details on using TDM plug-ins, consult
Chapter 16: TDM Bussing, Routing &
Plug-Ins in your Audio Reference Manual.
The TDM Plug-in specification was
developed by Digidesign, Inc.
DSP COMMANDS IN VISION
The following DSP menu commands are
now included with Vision:
• Fade/Crossfade
• Pitch Shift
• Formant Shift
• Time Scale
• Adjust Audio Tempo
For details on using these commands, see
Chapter 31: DSP Menu in your Audio Reference
Manual.
NOTE: Audio-to-MIDI and MIDI-to-Audio
are not available in Vision. To get these
commands you must upgrade to Studio
Vision Pro.
Figure 2.2: Settings, Real-Time
There are two new items in the Settings
Window, both related to audio. They
include:
• Sustain audio across segments
When checked, audio events played
from a sequence event last for their
full duration—even if the referenced
segment or sequence stops playing.
If you uncheck this option, the audio
will stop playing when the sequence
event ends, or when it reaches the
loop end point (if it is set to repeat).
• Audio edits occur...
Select “immediately” from this pop-up
menu to have audio edits reflected
almost instantaneously for playback.
Choosing this option does, however,
cause audio edits to interrupt audio
playback briefly.
If you instead select “smoothly,” edits
are reflected more slowly, but with no
disruption in audio playback.
Vision & Studio Vision Pro — Version 4.1 Manual Supplement 9