Vision and Studio Vision Pro Version 4.1 Manual ... - House of Synth

PART 3: The Acadia Audio System
Anatomy of the Send Area
Send Selector
Use the Send Selector to tell Vision where
to send the audio signal:
Figure 7.13: Anatomy of the Send area
The Send area, once enabled, contains the
following items:
Send Selector pop-up
Pre/Post Fader button
Send Level
Press and hold the mouse on the
Send Selector.
Vision opens a pop-up menu of routing
options.
NOTE: The Pre/Post Fader button and
Send Level numerical are disabled and
invisible until you specify a send destination
using the Send Selector pop-up. This
provides a visual way to quickly locate
active channel sends on a busy mixing
console.
The following sections discuss each of the
Audio Send parameters in detail.
You can choose between the following
audio send destinations:
• No send
The audio signal is not sent to an
external output or bus.
• Bus
Choose “Bus” to open a submenu of
16 busses.
Sending audio to a bus is a great way
to create submixes (see page 74) or
to share a single plug-in with numerous
audio channels (see page 73).
Audio channels sent to busses will
not be routed until the bus output is
assigned to an actual hardware
output.
Busses can be mono or stereo as
specified in the Audio Instruments &
Routings Window. For more information,
see Mono & Stereo Busses
(pg. 58).
56 Opcode Systems, Inc.