WM, Workshop Manual, K650, K700, K950, K1250, 2001-06, Power ...
WM, Workshop Manual, K650, K700, K950, K1250, 2001-06, Power ...
WM, Workshop Manual, K650, K700, K950, K1250, 2001-06, Power ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Ignition system<br />
2<br />
Tips!<br />
Tap the flywheel puller screw sharply with<br />
a hammer if the flywheel sits tight.<br />
Tips!<br />
The flywheel may sit very tightly on the<br />
shaft. To simplify dismantling - tap the<br />
flywheel pullers screw sharply a few<br />
times. Hold the engine in the air with the<br />
handle on the flywheel puller.<br />
Starter pawls<br />
Mod. 650, 700, 950, 1250<br />
Check the starter pawls for wear and<br />
damage.<br />
Replace damaged parts.<br />
The pawls are mounted on the flywheel<br />
with a contact screw.<br />
Pay attention to the spacer washer (A)<br />
during dismantling and assembly.<br />
Starter pawls<br />
Mod.650, 700, 950, 1250<br />
Check the starter pawls for wear and<br />
damage.<br />
Replace damaged parts.<br />
The pawls are mounted on the flywheel<br />
with contact screw and spacer washer<br />
(A).<br />
It is important not to forget the washer<br />
during assembly.<br />
Check that the pawls move freely.<br />
A<br />
Assembly<br />
Check that the keyway and key in the<br />
crankshaft are undamaged. (Mod. 650,<br />
700, 1250)<br />
Assembly<br />
Check that the keyway and key in the<br />
crankshaft are undamaged. (Mod. 650,<br />
700, 1250)<br />
Fit where appropriate a new key and<br />
make sure that it is positioned correctly in<br />
the keyway.<br />
Check that the keyway and the cast key<br />
(mod. 950) in the flywheel are undamaged.<br />
Fit the flywheel.<br />
Check that the keyway and the cast key<br />
(mod. 950) in the flywheel are undamaged.<br />
Fit the flywheel and check that the key<br />
and keyway are correctly positioned<br />
before the flywheel nut is tightened.<br />
Tighten the nut with tightening torque 25–<br />
35 Nm.<br />
17