WM, Workshop Manual, K650, K700, K950, K1250, 2001-06, Power ...

Fuel system
3
Carburettor
Dismantling, all models
Dismantle all covers and air filters so that
the carburettor becomes accessible.
Blow clean the carburettor chamber with
compressed air.
Carburettor
Dismantling, all models
Dismantle all covers and air filters so that
the carburettor becomes accessible.
Close the choke flap to prevent dirt penetrating
into the engine.
Blow clean the carburettor chamber with
compressed air.
Mod. 650, 700
Remove the screw guide and lock washer
which holds the throttle push rod at
the lever.
Mod. 650, 700
1. Remove the screw guide from the
carburettor’s adjusting screws.
2. Bend away the lock washer which
holds the throttle push rod at the lever
by means of a screwdriver.
NOTE!
EPA-models have fixed jets and consequently
do not have screwdriver guides.
Remove the fuel hose.
Release the carburettor screws and lift
off the carburettor together with the choke
control, air filter connection, and middle
piece.
3. Remove the fuel hose from the carburettor.
4. Unscrew the carburettor screws. Insert
hex key 502 50 18-01 through the
hole in the stop control when the left
screw is to be unscrewed.
5. Lift off the carburettor together with
the choke control, air filter connection
and middle piece.
For service procedures see ”Disassembly
of carburettor”.
502 50 18-01
Carburettor
Carburettor
4
1
Mod. 950
Blow clean the carburettor area with
compressed air before the carburettor is
removed.
Mod. 950
Dismantle all covers and air filter. Blow
clean the carburettor area with
compressed air.
Dismantle the following:
1. Impulse hose
2. Fuel hose
3. Choke lever
2
4. Throttle lever (from throttle control)
3
23