WM, Workshop Manual, K650, K700, K950, K1250, 2001-06, Power ...
WM, Workshop Manual, K650, K700, K950, K1250, 2001-06, Power ...
WM, Workshop Manual, K650, K700, K950, K1250, 2001-06, Power ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
3<br />
Fuel system<br />
Lift off the half of the grip and the throttle<br />
control.<br />
Note the washer under the throttle control<br />
and the sleeve inside the control.<br />
Lift off the half of the grip.<br />
NOTE!<br />
One end of the return spring for the throttle<br />
control catch goes in the hole on the<br />
throttle control.<br />
Lift off the throttle control. Note the washer<br />
under the throttle control and the<br />
sleeve inside the control so that they are<br />
not lost during cleaning.<br />
Fit in the reverse order to dismantling.<br />
Replace damaged or worn parts.<br />
Fit all parts in the left-hand half of the grip.<br />
1. Place the spring for the throttle control<br />
catch in position round the pin with the<br />
hole in it.<br />
2. Place the throttle control catch in position.<br />
Hook in the spring in the hole in the<br />
throttle control and move it to the correct<br />
position opposite the screw hole.<br />
Lock the throttle control with the catch<br />
and insert the screw in the throttle control’s<br />
supporting sleeve.<br />
3. Push the sleeve in the throttle control<br />
from underneath.<br />
4. Hold the sleeve in position with your<br />
forefinger and hook the spring in the<br />
hole in the throttle control.<br />
5. Move the throttle control to the correct<br />
position opposite the screw hole.<br />
6. Press in the start throttle catch and<br />
lock the throttle control in start position.<br />
7. Insert the screw in the throttle control’s<br />
supporting sleeve.<br />
36