WM, Workshop Manual, K650, K700, K950, K1250, 2001-06, Power ...

Fuel system
3
Fit the throttle control and safety catch in
the reverse order to dismantling.
Check that the spring on the catch goes
into the hole in the throttle control.
1. Push the throttle control with attached
throttle wire into the rear grip.
2. Enter the back edge of the safety
catch into the grip.
3. Check that the spring goes into the
hole in the throttle control.
4. Press down the safety catch until it
clicks into the throttle control.
5. Press in the three bearing pins and
check that the throttle control and
safety catch function as intended.
39