WM, Workshop Manual, K650, K700, K950, K1250, 2001-06, Power ...

5
Cylinder and piston
Fit a new cylinder base gasket.
Carefully scrape off old gasket residue
from the cylinder and cylinder base surface
on the crankcase.
Place a new gasket in position on the
crankcase. Gasket paste is
recommended!
Lubricate the cylinder bore with a few
drops of oil and push down the cylinder
over the piston.
Screw tight the cylinder.
Lubricate the cylinder bore with a few
drops of oil and push down the cylinder
over the piston. Use tool 502 50 70-01 to
simplify the work.
NOTE!
Do not turn the cylinder. There is a risk of
breaking the piston ring.
Screw tight the screws for the cylinder
crosswise.
502 50 70-01
Mod. 650, 700
Fit the cylinder in the same way as
described above.
Check the middle piece for cracking or
other damage before fitting it.
Replace if necessary the middle piece.
Mod. 650, 700
Fit the cylinder in the same way as
described above.
Check the middle piece for cracking or
other damage before fitting it.
Replace the middle piece if necessary.
Fit the carburettor and other parts in the
reverse order to dismantling.
Mod. 950
Fit the cylinder in the same way as
described above.
Fit the other parts in the reverse order to
dismantling.
Mod. 950
Follow the instructions for ”Cleaning,
inspection”, ”Assembly” and ”Decompression
valve” before fitting the piston
and cylinder.
TIP!
Fit the intake pipe and impulse hose on
the cylinder before fitting it on the
crankcase.
Fit the other parts in the reverse order to
dismantling.
56