WM, Workshop Manual, K650, K700, K950, K1250, 2001-06, Power ...

4
Centrifugal clutch
The clutch drum’s bearing is lubricated
automatically with the oil in the fuel mixture
which is pressed out through the channel
in the crankshaft.
The clutch drum’s bearing is lubricated
automatically with the oil in the fuel
mixture.
When the piston moves down in the cylinder
the fuel mixture in the crankcase is
compressed. A small part of this mixture
is pressed out through the channel in the
crankshaft and provides the needle
bearing with sufficient lubrication.
Lubricate the clutch drum’s needle bearing
with a little grease and fit the clutch drum
on the crankshaft.
Fit the spacer washer and centrifugal
clutch.
Mod. 950, 1250
Fit the clutch shoes.
Fit the springs from the back of the clutch.
Check that the lubrication hole in the
crankshaft is open.
Clean it with a piece of wire if necessary.
Mod. 950, 1250
Fit the clutch shoes on the hub.
Fit the springs from the back of the clutch
by pressing them in place with your thumbs
or with a screwdriver.
Check that the lubrication hole in the
crankshaft is open.
Clean it with a piece of wire if necessary.
NOTE!
Remember the spacer sleeve (A) behind
the clutch drum when the clutch is refitted
on the crankshaft.
A
46