WM, Workshop Manual, K650, K700, K950, K1250, 2001-06, Power ...
WM, Workshop Manual, K650, K700, K950, K1250, 2001-06, Power ...
WM, Workshop Manual, K650, K700, K950, K1250, 2001-06, Power ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
3<br />
Fuel system<br />
Speed limiter<br />
Mod. 650, 700<br />
A speed limiter is fitted on the side of the carburettor housing.<br />
The speed limiter is fixed with Loctite and should not be released during servicing of<br />
the carburettor.<br />
A<br />
When the engine speed is less than 9,200 rpm the ball seals the extra fuel channel (A).<br />
The pressure of the spring presses the ball against the seat with a precise proven<br />
pressure.<br />
9600 r/min<br />
When the engine speed exceeds the speed limit (9,600 ± 400 rpm) the spring-loaded<br />
ball opens the extra fuel channel (A). The engine thereby receives extra fuel, begins to<br />
putter and stops overspeeding.<br />
Compensation insert for blocked air filter<br />
The carburettor has been fitted with a compensation insert to prevent the engine<br />
receiving an increasing amount of fuel as the air filter becomes blocked. This transfers<br />
the underpressure in the carburettor’s inlet to the top of the metering diaphragm, as<br />
opposed to the atmospheric pressure in a standard carburettor. The pressure difference<br />
between the top and bottom of the diaphragm therefore remains constant and does not<br />
increase as the air filter becomes blocked. The fuel supply to the carburettor’s main jet<br />
nozzle is therefore always maintained at the correct level.<br />
A<br />
Check that the small O-ring (A) is in place<br />
when the air filter union is installed.<br />
It is important for correct function of the<br />
compensation device that the O-ring is<br />
neither damaged or missing.<br />
26