WM, Workshop Manual, K650, K700, K950, K1250, 2001-06, Power ...

1
Starter unit
Anchor the starter rope in the starter
handle with a double knot.
Insert the rope through the rope guide in
the starter housing and anchor it in the
starter handle with a double knot.
Tension the return spring.
Check that the spring tension is completely
released, and lift the starter cord up into
the cut-out in the pulley.
Tension the return spring.
1. Check that spring tension is competely
released.
2. Lift the starter cord up into the cut-out
in the pulley.
Wind the pulley 7 turns clockwise.
3. Wind the pulley 7 turns clockwise.
Be careful and brake the pulley with
your thumb.
Max
Pull the cord out completely and check
that the pulley can be turned at least a
further half turn.
4. Pull the cord out completely and check
that the pulley can be turned at least
a further half turn.
+1/2
6