WM, Workshop Manual, K650, K700, K950, K1250, 2001-06, Power ...
WM, Workshop Manual, K650, K700, K950, K1250, 2001-06, Power ...
WM, Workshop Manual, K650, K700, K950, K1250, 2001-06, Power ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Centrifugal clutch<br />
4<br />
Place an object which is approx. 5.5 mm<br />
(0.22") thick between the clutch shoe and<br />
the spoke.<br />
Bend away the clutch spring.<br />
Place an object (e.g. a nut) which is<br />
approx. 5.5 mm (0.22") thick between the<br />
clutch shoe and the spoke on the clutch<br />
hub on the back of the clutch.<br />
Bend away the clutch spring with a<br />
screwdriver.<br />
Min. 1 mm<br />
Clean and inspect the clutch parts for<br />
damage and wear.<br />
Clean and inspect the clutch hub’s spokes<br />
and the clutch shoes for wear.<br />
There must be material thickness of at<br />
least 1 mm (0.04") left at the most worn<br />
point on the clutch shoes.<br />
All the shoes must be replaced at the<br />
same time.<br />
Inspect the wear on the clutch drum, the<br />
pulley and the inner diameter.<br />
It must not exceed 75.5 mm (2.97").<br />
Check the wear on clutch drum’s inner<br />
diameter. It must not exceed 75.5 mm<br />
(2.97"). If so, replace the clutch drum.<br />
Check also the wear on the pulley. If the<br />
side surfaces are heavily worn and/or<br />
damaged the clutch drum must be<br />
replaced.<br />
Replace the needle bearing if the clutch<br />
drum is loose on the shaft.<br />
If the needle bearing in the clutch drum is<br />
worn (the drum is loose on the shaft) it<br />
should be replaced with a new one.<br />
Press out the bearing with a vice and a<br />
suitable sleeve (Ø 17.5 mm, 0.69").<br />
43