WM, Workshop Manual, K650, K700, K950, K1250, 2001-06, Power ...

3
Fuel system
A
Dismantle the screw (A) and then the two
carburettor screws.
Lift off the carburettor.
Remove the screw (A) and then the two
carburettor screws.
Insert key 502 50 18-01 through the hole
in the crankcase and tank part.
Lift off the carburettor together with the air
filter connection and throttle lever.
Fit in the reverse order to dismantling.
502 50 18-01
Mod. 1250
Press off the rubber support from the
carburettor intake.
Mod. 1250
Press off the rubber support from the
carburettor intake with a screwdriver.
NOTE!
Do not pull off the support from the
crankcase since it is difficult to refit without
separating the crankcase and tank part.
4
Dismantle the fuel hose.
Unscrew the carburettor screws, remove
the choke lever and hook off the throttle
wire.
Fit in reverse order to dismantling.
1. Dismantle the fuel hose.
2. Unscrew the carburettor screws.
3. Remove the choke lever from the
lever on the carburettor.
4. Hook off the throttle wire
2
2
1
3
Lift off the carburettor together with the
intake neck.
Fit in the reverse order to dismantling.
Assembly
Mod. 650, 700
Fit the carburettor in the reverse order to
dismantling.
Assembly
Mod. 650, 700
Fit the carburettor to the cylinder in the
reverse order to dismantling.
Use new seals.
Place the air filter connection (with
screws), choke control and middle piece
on the carburettor.
Hold the complete carburettor unit against
the cylinder. Press down the choke control
in its guide and tighten the screws. Check
that the seal closest to the cylinder is
correctly positioned! Connect the throttle
push rod and fit the screw guide over the
carburettor’s adjusting screws.
24