Owner's Manual - Smarthome
Owner's Manual - Smarthome
Owner's Manual - Smarthome
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
42 Multi-Wave PE653-PE953 Installation Guide<br />
To Reset the PE953 Hand-Held Controller<br />
1.<br />
Press and release any button on the Hand-Held Controller to wake it from sleep. (The unit<br />
goes to sleep to conserve battery life when it has been idle for 60 seconds.)<br />
2. Press and hold the and buttons at the same time<br />
to put the device into programming mode. You are in programming<br />
mode when the LEARN MODE screen is displayed, as shown at the<br />
right.<br />
NOTE: If you pause in programming for more than 30 seconds,<br />
the screen automatically returns to the previous screen.<br />
3. Press and release the function button to select RESET<br />
CONTROLLER. The screen displays four options, as shown.<br />
LEARN MODE 00-00P<br />
1 RESET CONTROLLER<br />
2 RESET DEVICE<br />
3 INCLUDE DEVICE<br />
4 ADD TO SCENE<br />
5 REMOVE FROM SCENE<br />
UP-PREVIOUS DWN-MORE<br />
RESET CNTRL 00-00P<br />
1 RESET NET AND CFG<br />
2 RESET NET ONLY<br />
3 RESET CFG ONLY<br />
4 ABORT RESET<br />
4. Press and release the function button to select RESET NET<br />
AND CFG. This will delete any existing network connections as<br />
well as any programming entered using the Hand-Held Controller.<br />
The screen requests confirmation, as shown.<br />
RESET CNTRL 00-00P<br />
PLEASE PRESS<br />
5 TO CONTINUE<br />
ENTER TO CANCEL<br />
5. Press and release the function button to select CONTINUE.<br />
If the action is successful, the screen displays the words PLEASE<br />
WAIT followed by SUCCESSFUL, as shown.<br />
Any pre-existing network or configuration programming in the Hand-<br />
Held Controller is now deleted.<br />
To Reset the PE653 Receiving Device<br />
1. Press and release any button on the Hand-Held Controller to wake it from sleep. (The unit<br />
goes to sleep to conserve battery life when it has been idle for 60 seconds.)<br />
2. Press and hold the and buttons at the same time to<br />
put the device into programming mode, as shown at the right.<br />
RESET CNTRL 00-00P<br />
SUCCESSFUL<br />
LEARN MODE 00-00P<br />
1 RESET CONTROLLER<br />
2 RESET DEVICE<br />
3 INCLUDE DEVICE<br />
4 ADD TO SCENE<br />
5 REMOVE FROM SCENE<br />
3. Press and release the function button to select RESET DEVICE.<br />
The screen displays instructions.<br />
UP-PREVIOUS DWN-MORE<br />
LEARN MODE 00-00P<br />
2 RESET DEVICE<br />
PRESS BUTTON ON<br />
DEVICE TO RESET<br />
4. Using a pen or pencil, press the INCLUDE<br />
button — to the right of the red light — as<br />
shown.<br />
LEARN MODE 00-00P<br />
2 RESET DEVICE<br />
PRESS BUTTON ON<br />
DEVICE TO RESET<br />
SUCCESSFUL<br />
Copyright © 2010 Intermatic, Inc.