ALLEN BRADLEY 1747-L551 PLC Processor

1–6
Quick Start for Experienced Users
7. Load your software. Reference
Refer to your software package’s documentation. –
8. Establish communications to the processor. Reference
Follow the steps below:
Chapter 8
1. Refer to the following to establish communications between the processor and your personal
(Starting Up Your
Control System)
computer.
Processor: Procedure:
SLC 5/01
Connect 1747-PIC from the processor to your personal computer.
SLC 5/02
Connect 1747-PIC from the processor to your personal computer.
SLC 5/03
Connect 1747-PIC from the processor to your personal computer or a 1747-CP3 cable from
channel 0 of the processor to the personal computer serial port.
SLC 5/04
Connect a 1747-CP3 cable from channel 0 of the processor to the personal computer serial port
or use a KT, KTX, KT2, or PCMK card.
SLC 5/05
Connect a 1747-CP3 cable from channel 0 of the processor to the personal computer serial port.
For Ethernet connection, connect channel 1 of the processor and the PC Ethernet Card to an
Ethernet hub using 10Base-T cable.
2. Set the communication parameters of software to match the default parameters of the processor:
• SLC 5/01, SLC 5/02, and SLC 5/03 channel 1
DH-485
19.2K baud
Node Address = 1
• SLC 5/03 and SLC 5/04 only:
channel 0 configuration:
DF1 Full Duplex
No Handshaking
1200 baud
CRC Error Check
Duplicate Packet Detect On
No Parity
1 Stop Bit
• SLC 5/04 only:
channel 1 configuration:
DH+
57.6K baud
Node Address = 1
• SLC 5/05 only:
channel 0 configuration:
DF1 Full Duplex:
No Handshaking
19.2K baud
CRC Error Check
Duplicate Packet Detect On
No Parity
1 Stop Bit
channel 1 configuration:
Driver: Ethernet ➀
➀ Configuring with BOOTP enabled so that a BOOTP server on the network can automatically provide the SLC 5/05 with the
configuration necessary to start communicating over Ethernet. See Appendix G for more information.
Publication 1747-6.2