UNIVERGE OW5000 Configuration Guide - NEC Corporation of ...

3-6 WatchDog
Step 3
Select the OW5000 application to be monitored by WatchDog for the
specific Host Machine from the Installed OW5000 Application field.
If nothing is shown, all the OW5000 applications are already monitored by
WatchDog.
NOTE
Step 4
Step 5
Select the Monitor Service box under Options if WatchDog monitoring
is to be enabled at this time.
Enter the Retry Interval (in seconds) for the restart of this application
following a shutdown.
NOTE
Some applications take longer to completely shut down than others. Selecting a retry
interval that is too short may result in a service race condition where a service may
try to restart before it is completely shut down. This can result in serious problems
with Windows and the services may not start properly.
Step 6
Select the Add button to add the service item, or Cancel to leave this
function without saving your changes. Once an application item is added,
it will then be listed on the WatchDog Helper main window of monitored
service applications.
Deleting a Service
Use the following steps to delete a monitored service application from
WatchDog.
Step 1
Do one of the following in the main WatchDog Helper window:
—Select OW5000 Application, then click Tools > Delete Service.
—Right-click the name of any OW5000 Application in the main window
and select Delete Service.
—Select OW5000 Application, then click the Delete Service
button.
A WatchDog Helper Delete Service dialog box displays (Figure 3-6).
Figure 3-6 WatchDog Helper Delete Service dialog box
UCE Application Platform (UNIVERGE OW5000) Configuration Guide