UNIVERGE OW5000 Configuration Guide - NEC Corporation of ...

2-38 OW5000 Configuration
NOTE
so that OW5000 can properly dial and interpret incoming numbers
across the CCIS network.
The Source PBX section describes how incoming numbers from these
source PBXs to the current PBX should be disassembled to find the
actual extension of the calling party. This is done by entering the
Incoming Prefix that should be removed to find the extension. It is
possible to have more than one entry per source PBX in case numbers
can arrive in various formats from this PBX.
A Prefix is not required for the PBX(UGN), which uses the IP Centrex Feature,
because the Extension has its prefix as part of the extension number.
Step 2
To add a new Destination PBX, click Add New Destination PBX. An
Add Destination PBX dialog box displays (Figure 2-41).
Figure 2-41 Add Destination PBX dialog box
Step 3
Step 4
Step 5
Step 6
Step 7
Select the desired Destination PBX from the drop-down list.
Enter the Dialing Prefix number.
Enter the Extensions Beginning with number in the text field. This
parameter is used only when different access codes need to be applied
for each beginning number. This configuration is not often required.
Do one of the following:
—Click Apply to save the Destination PBX without exiting the dialog
box.
—Click Done to save the Destination PBX and exit the dialog box.
—Click Cancel to exit the dialog box without saving the Destination
PBX.
To add a new Source PBX, click Add New Source PBX. An Add Source
PBX dialog box displays (Figure 2-42).
UCE Application Platform (UNIVERGE OW5000) Configuration Guide