UNIVERGE OW5000 Configuration Guide - NEC Corporation of ...

2-30 OW5000 Configuration
Step 6
Step 7
Step 8
Step 9
Step 10
Step 11
Step 12
Step 13
Select the Split Call Forward check box if this feature is configured on
your PBX. Split Call Forwarding enables Dterm telephone users to set
different call forwarding patterns for internal versus external calls.
Select a Location from the drop-down list. The location must be
configured before this step. For more information, see “Locations” on
page 2-32.
Select the proper Pbx Reconnect Delay time from the drop-down list.
This parameter is a delay timer and determines how much time should
pass until the next reconnect request is sent to the PBX when the
OW5000 realizes a disconnection between the server and the PBX.
Default value is 30 seconds.
Select the proper Heartbeat Timeout value from the drop-down list. This
is a parameter which indicates the heartbeat timeout between the server
and the PBX. Default value is 128 seconds.
Check the UGN (User Group Number) if the IP centrex feature is used.
Enter the Prefix number. This parameter typically consists of Access
Number + Office Code (PBX ID). This parameter is mandatory in multi-
PBX systems to identify the same extension number. This parameter is
not required for a closed network system.
Enter the SIP Server IP Address (Port). The IP Address of SP must be
assigned in this edit box for SV7000 and SR-MGC. Enter the SIP-BOX
IP address for the IPX and IPS. All SIP Server IP addresses must be
entered if there is more than one SIP Server. In the VRRP environment,
both physical and logical IP addresses must be entered. The Default Port
number is 5060 for SP. Set Act side IP Address of LAN1 for SV8500
system. Set 3 IP Addresses (Act type,type 0 and 1) of IP Address for a
redundancy system.
Click Add to add a port, or Remove to remove a port.
UGN, Prefix, and SIP Server IP Address (Port) fields are needed for the SIP
Presence function.
NOTE
Step 14
Do one of the following:
—Click Apply to save the information.
—Click Done to add the PBX Configuration and close the dialog box.
—Click Cancel to exit without saving the new PBX configuration.
UCE Application Platform (UNIVERGE OW5000) Configuration Guide