UNIVERGE OW5000 Configuration Guide - NEC Corporation of ...

OW5000 Configuration 2-15
Step 2 To delete a PBX Access Control, click the Trashcan icon next to the
desired PBX Name (Figure 2-18). Confirm the deletion when the dialog
box displays. If a watcher PBX is deleted which is in the Allow List, the
PBX moves it to the Deny List. If a watcher PBX is deleted which is in
Deny List, the PBX moves it to the Allow List.
Conference Bridge Management
Selecting Conference Bridge from the OW5000 Applications Options
dialog box (Figure 2-13) displays a Conference Bridge Management
dialog box (Figure 2-19).
A conference bridge allows users to conference with more than three
parties. The conference bridges are typically 8 or 16 ports and one caller
can be on each port.
Special Conditions of Conference Server
Please note the conditions below for Conference Server when
programming the PBX to conference with four or more parties.
There are several ways to configure the bridges for conference, but
these are the operations the Conference Manager requires and the
conditions it expects them to work under.
• Do not allow the PBX to move a caller to another port when the port is
busy.
• Turn off the ringback suppression feature of the PA-CFTB conference
card by setting Element 3 to the off position on Switch 1.
If the PBX is programmed for four or more parties to be used for
OW5000 UC Conference Server, the application must be used; it cannot
be done manually. If the bridge is not setup this way, the Conference
Server will not work for a conference of four or more parties. For more
information on how to program the PBX for four or more parties, please
refer to the PBX programming guide for each PBX type.
Follow the steps below to configure Conference Bridges:
Figure 2-19 Conference Server Options dialog box
UCE Application Platform (UNIVERGE OW5000) Configuration Guide