UNIVERGE OW5000 Configuration Guide - NEC Corporation of ...

2-28 OW5000 Configuration
Adding a PBX Configuration
Clicking Add New PBX from the PBX Management dialog box displays a
PBX Configuration—Add New dialog box (Figure 2-31).
Figure 2-31 PBX Configuration—Add New dialog box
PBX Settings
When adding a new PBX Configuration, the first dialog box to display is
PBX Settings.
Step 1
Step 2
Enter a Name for the PBX in the PBX Name field. This is a label used to
identify the PBX. It is displayed in various list boxes to identify the
location of extensions, and therefore should most likely be made to
describe the site where it is located. Once the PBX name is saved, it
cannot be changed.
Enter the IP address of the PBX in the IP Address field (xxx.xxx.xxx.xxx.
If you do not know the PBX IP address, contact your local PBX system
administrator. Determining the IP address of your PBX depends on the
particular type of PBX selected, as shown in (Table 2-3). If you are using
a NetFusing system, enter the IP Address where IP (OAI Interface
Processor) is enabled.
UCE Application Platform (UNIVERGE OW5000) Configuration Guide