You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Complete the Job - 124<br />
Rinse Equipment<br />
JT5 Operator’s <strong>Manual</strong><br />
Rinse Equipment<br />
Using Optional Washwand<br />
Connect the washwand at quick connect at rear<br />
of unit. Close valve (shown) to shut off flow to<br />
spindle.<br />
IMPORTANT:<br />
• Never use high flow when using wash<br />
wand.<br />
• Use extreme caution when working with<br />
highly pressurized water.<br />
Incorrect procedures could result in death, injury, or property damage.<br />
Learn to use equipment correctly.<br />
NOTICE: Failure to prime the drilling fluid pump will cause flow fluctuations, which will make it difficult to<br />
control the washwand. For instructions, see “Connect Fluid System” on page 109.<br />
Pressurized fluid or air could pierce skin and cause injury<br />
or death. Stay away.<br />
Spray water onto equipment to remove dirt and mud. Some pressure might be needed to remove dried<br />
mud from wrench area.<br />
NOTICE: Do not spray water onto operator’s console. Electrical components could be damaged. Wipe<br />
down instead.<br />
CMW
Change language