INfinity 510 Protocol Reference Guide - Sirit

More documents

Recommendations

Info

Chapter 17 - Errors Namespace error.tag.unsupported_command This response indicates a tag operation failed because the command is not supported by the tag. error.tag.verify_failed This response indicates a tag verify operation (read back after write) failed. error.tag.protocol.isoc.insufficient_power This response indicates an ISO-C tag operation failed because the tag has insufficient power to perform the memory-write operation. error.tag.protocol.isoc.memory_locked This response indicates an ISO-C tag operation failed because the specified memory location is locked or permalocked and not writeable or readable. error.tag.protocol.isoc.memory_overrun This response indicates an ISO-C tag operation failed because the specified memory location does not exist or the PC value is not supported by the tag. error.tag.protocol.isoc.non_specific This response indicates an ISO-C tag does not support error-specific codes. error.tag.protocol.isoc.other_error This response indicates an ISO-C tag operation failed with no specific error. 224 INfinity 510 Protocol Reference Guide
Chapter 18 - Events Namespace EVENTS NAMESPACE Events Description Type event.connection New event channel established. event event.info Informational event. event event.configuration.change Configuration change event. event event.debug.trace.iop Debug tracing information sent from reader. event event.debug.trace.modem Sends debug tracing information out of event event.dio.all Reports state of all digital inputs/outputs. event event.dio.in. Digital IO event. event event.dio.out. Digital IO event. event event.error.antenna Reader detected antenna error condition. event event.error.communication Reader detected a communication error. event event.error.configuration Reader detected a configuration error. event event.error.environmental Reader detected environmental error condition. event event.error.file_handling Reader detected error condition while operating on file. INfinity 510 Protocol Reference Guide 225 event event.error.hw Reader detected HW error condition. event event.error.radio Reader detected error condition with radio. event event.error.sw Reader detected SW error condition. event event.status. antenna_state_change Antenna state change. event event.status.antenna_transition Reader transitioned to new antenna port. event event.status.channel_power_re port Power report for a channel. event event.status.channel_state Report a change in state for a channel. event event.status.channel_transition Reader has transitioned to new channel. event event.status.inventory_end Reader has completed inventory round. event event.status. inventory_rounds_complete Inventory rounds have completed. event event.status.inventory_start Reader has started an inventory round. event event.status.modem_halted Reader detected unrecoverable error and halted. event event.status.modem_ready Reader ready to process commands. event event.status.tag_collision event.status.tag_loss_of_signal Reader detected tag collision during inventory round. Reader read tag but signal loss prevented CRC validation. event event event.status.tag_no_epc Tag's RN16 was ACK'd but no EPC was received. event
Page 2 and 3:
INfinity 510 Protocol Reference Gui
Page 4 and 5:
Conventions used in this manual The
Page 6 and 7:
Contents Tag Operations............
Page 8 and 9:
Chapter 1 - Introduction TYPES OF I
Page 10 and 11:
Chapter 2 - User Interface Overview
Page 12 and 13:
Chapter 2 - User Interface Overview
Page 14 and 15:
Chapter 3 - Command Overview COMMAN
Page 16 and 17:
Chapter 3 - Command Overview DATA T
Page 18 and 19:
Chapter 3 - Command Overview unauth
Page 20 and 21:
Chapter 4 - Reader Behavior Creatin
Page 22 and 23:
Chapter 4 - Reader Behavior READER
Page 24 and 25:
Chapter 4 - Reader Behavior Protoco
Page 26 and 27:
Chapter 4 - Reader Behavior Specify
Page 28 and 29:
Chapter 4 - Reader Behavior Reading
Page 30 and 31:
Chapter 4 - Reader Behavior The fol
Page 32 and 33:
Chapter 4 - Reader Behavior Write T
Page 34 and 35:
Chapter 4 - Reader Behavior Lock an
Page 36 and 37:
Chapter 4 - Reader Behavior The fol
Page 38 and 39:
Chapter 4 - Reader Behavior Tag Dat
Page 40 and 41:
Chapter 4 - Reader Behavior A tag i
Page 42 and 43:
Chapter 5 - Embedded Reader Applica
Page 44 and 45:
Page 46 and 47:
Page 48 and 49:
Chapter 6 - Tag Protocol Support Ph
Page 50 and 51:
Chapter 7 - Reader Namespace READER
Page 52 and 53:
Chapter 7 - Reader Namespace reader
Page 54 and 55:
Page 56 and 57:
Page 58 and 59:
Page 60 and 61:
Page 62 and 63:
Chapter 7 - Reader Namespace The fo
Page 64 and 65:
Page 66 and 67:
Page 68 and 69:
Page 70 and 71:
Page 72 and 73:
Chapter 8 - Setup Namespace SETUP N
Page 74 and 75:
Chapter 8 - Setup Namespace setup.p
Page 76 and 77:
Chapter 8 - Setup Namespace setup.s
Page 78 and 79:
Chapter 8 - Setup Namespace setup.v
Page 80 and 81:
Chapter 9 - Info Namespace INFO NAM
Page 82 and 83:
Chapter 9 - Info Namespace info.loc
Page 84 and 85:
Chapter 9 - Info Namespace info.ser
Page 86 and 87:
Chapter 9 - Info Namespace info.tim
Page 88 and 89:
Chapter 10 - Version Namespace vers
Page 90 and 91:
Chapter 11 - Com Namespace COM NAME
Page 92 and 93:
Chapter 11 - Com Namespace com.even
Page 94 and 95:
Chapter 11 - Com Namespace com.netw
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Chapter 11 - Com Namespace com.seri
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Chapter 12 - Tag Namespace Tag Comm
Page 114 and 115:
Chapter 12 - Tag Namespace tag.lock
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Chapter 12 - Tag Namespace tag.read
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Chapter 12 - Tag Namespace tag.writ
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Chapter 12 - Tag Namespace tag.db.g
Page 136 and 137:
Chapter 12 - Tag Namespace tag.db.s
Page 138 and 139:
Chapter 12 - Tag Namespace tag.filt
Page 140 and 141:
Chapter 12 - Tag Namespace tag.filt
Page 142 and 143:
Chapter 12 - Tag Namespace tag.repo
Page 144 and 145:
Page 146 and 147:
Page 148 and 149:
Page 150 and 151:
Page 152 and 153:
Chapter 13 - DIO Namespace dio.in.
Page 154 and 155:
Chapter 13 - DIO Namespace dio.out.
Page 156 and 157:
Chapter 14 - Antennas Namespace ant
Page 158 and 159:
Page 160 and 161:
Page 162 and 163:
Page 164 and 165:
Page 166 and 167:
Chapter 15 - Modem Namespace Modem
Page 168 and 169:
Chapter 15 - Modem Namespace Modem
Page 170 and 171:
Chapter 15 - Modem Namespace modem.
Page 172 and 173:
Page 174 and 175:
Page 176 and 177:
Page 178 and 179:
Page 180 and 181: Chapter 15 - Modem Namespace The fo
Page 182 and 183: Chapter 15 - Modem Namespace modem.
Page 186 and 187: Chapter 15 - Modem Namespace >>> mo
Page 218 and 219: Chapter 17 - Errors Namespace ERROR
Page 220 and 221: Chapter 17 - Errors Namespace error
Page 232 and 233: Chapter 18 - Events Namespace Event
Page 234 and 235: Chapter 18 - Events Namespace event
Page 246 and 247: Chapter 18 - Events Namespace demod
Page 250 and 251: Chapter 19 - Enum Namespace DIAG NA
Page 252 and 253: Chapter 20 - Enum Namespace ENUM NA
Page 254 and 255: Chapter 20 - Enum Namespace definit
Page 270 and 271: Index INDEX OF FUNCTIONS AND VARIAB
Page 272 and 273: Index modem.protocol.easalarm.contr
Page 274 and 275: This page intentionally left blank.
show all

INfinity 510 Protocol Reference Guide - Sirit

Create successful ePaper yourself

Delete template?

Save as template?