CIMCO CNC-Calc v2.5 User Guide

More documents

Recommendations

Info

61 Now close the parameters dialog with OK and click on Export Clipboard. The NC operation is now in the clipboard, and is ready for insertion. Change the window to the NC program, and move to the very end, by pressing Ctrl- End. Insert the text from the clipboard, either by pressing Ctrl-v, or selecting Edit Paste from the drop down menu. The NC program in the Editor now consists of three operations, and since we use the same tool for the contour and pocket operation we will not insert a tool in front of the pocket operation. Now save the program the NC program as CNC-Calc v2 Tutorial 4.NC
62 13. Tutorial 5 Backplot in the Editor One of the advantages of running CNC-Calc inside CIMCO Edit v5 is that the editor can be used to manipulate and backplot the NC programs generated in CNC-Calc. In the following we will setup the backplot, and verify the program. 13.1. Before you start The first thing to do before drawing a new part is to set the menu parameters. Start CIMCO Edit v5 and select Setup > Show Toolbars. Make sure all toolbars are displayed as shown in the image below. Toolbars can also be displayed or hidden by right-clicking on the toolbar area.
Page 1 and 2: www.cimco-software.com CIMCO CNC-Ca
Page 3 and 4: 28 9.1. Before you start The first
Page 5 and 6: 30 9.2. Draw the geometry Draw a re
Page 7 and 8: 32 Create a fillet between elements
Page 9 and 10: 34 Connect the inner elements Activ
Page 13 and 14: 38 10.2. Creation of Facing toolpat
Page 15 and 16: 40 Now close the parameters dialog
Page 17 and 18: 42 The line for the NC program is n
Page 21 and 22: 46 11.2. Creation of Contour toolpa
Page 23 and 24: 48 Side cuts are the cuts taken in
Page 25 and 26: 50 Lead in/out parameters describe
Page 27 and 28: 52 Click on Export Clipboard to cop
Page 31 and 32: 56 12.2. Creation of Pocket toolpat
Page 33 and 34: 58 At All Depths: If this check box
Page 35: 60 Lead in/out parameters describe
Page 39 and 40: 64 13.2. The first backplot When yo
Page 41 and 42: 66 After the tools have been config
Page 43 and 44: 68 Now everything has been configur
Page 45 and 46: 70 Select the file from CNC-Calc Ca
Page 47 and 48: 72 For the selection of the locatio
Page 49 and 50: 74 Once the toolbars have been sele
Page 51 and 52: 76 Select the feature Letter Millin
Page 53 and 54: 78 To verify the generated toolpath
Page 55 and 56: 80 16. Tutorial 8 Milling of TrueTy
Page 57 and 58: 82 In the bottom field you write th
Page 59 and 60: 84 The Letter Milling dialog has no
Page 61 and 62: 86 16.2. Pocket milling letters The
Page 63: 88 Verifying the toolpaths using th

CIMCO CNC-Calc v2.5 User Guide

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?