CIMCO CNC-Calc v2.5 User Guide

More documents

Recommendations

Info

29 The following window should now be displayed: Note If you hold the cursor over an icon a short description of its functionality will appear. You can change the colors of the drawing area by selecting Setup and then Colors from the dropdown menu.
30 9.2. Draw the geometry Draw a rectangle with sides = 150, height = 100 and corner radius = 12.5 Click on values: in the toolbar and enter the following First Corner X = 75 First Corner Y = 50 Second Corner X = -75 Second Corner Y = -50 Corner Radius = 12.5 Click on to approve the command. Draw a circle with radius = 5 defined by its center Click on in the toolbar. Enter Circle Radius = 5 Activate the snap function points). (circles center Snap to the center of the left topmost corner arc. Left-click to add the circle.
Page 1 and 2: www.cimco-software.com CIMCO CNC-Ca
Page 3: 28 9.1. Before you start The first
Page 7 and 8: 32 Create a fillet between elements
Page 9 and 10: 34 Connect the inner elements Activ
Page 11 and 12: 36 10.1. Before you start The first
Page 13 and 14: 38 10.2. Creation of Facing toolpat
Page 15 and 16: 40 Now close the parameters dialog
Page 17 and 18: 42 The line for the NC program is n
Page 21 and 22: 46 11.2. Creation of Contour toolpa
Page 23 and 24: 48 Side cuts are the cuts taken in
Page 25 and 26: 50 Lead in/out parameters describe
Page 27 and 28: 52 Click on Export Clipboard to cop
Page 31 and 32: 56 12.2. Creation of Pocket toolpat
Page 33 and 34: 58 At All Depths: If this check box
Page 35 and 36: 60 Lead in/out parameters describe
Page 37 and 38: 62 13. Tutorial 5 Backplot in the E
Page 39 and 40: 64 13.2. The first backplot When yo
Page 41 and 42: 66 After the tools have been config
Page 43 and 44: 68 Now everything has been configur
Page 45 and 46: 70 Select the file from CNC-Calc Ca
Page 47 and 48: 72 For the selection of the locatio
Page 49 and 50: 74 Once the toolbars have been sele
Page 51 and 52: 76 Select the feature Letter Millin
Page 53 and 54: 78 To verify the generated toolpath
Page 55 and 56:
80 16. Tutorial 8 Milling of TrueTy
Page 57 and 58:
82 In the bottom field you write th
Page 59 and 60:
84 The Letter Milling dialog has no
Page 61 and 62:
86 16.2. Pocket milling letters The
Page 63:
88 Verifying the toolpaths using th
show all

CIMCO CNC-Calc v2.5 User Guide

Create successful ePaper yourself

Delete template?

Save as template?