CIMCO CNC-Calc v2.5 User Guide

More documents

Recommendations

Info

65 13.3. Backplot tool setup. The following steps will show you how to setup the tools used in the backplot. Click on the Tool Setup icon in the floating toolbar indicated by arrow A. This will open the backplot Tool definition window. A When backplot persed the NC program, it detected, that there where two tools used. Since these tools have not been defined, the screen will look like the one to the left. In order to backplot the program correctly, we need to define these two tools. By changing the type and the diameter of the tools, we can create the correct setup. Please select and enter the values shown on the picture on the right. These are the same tool values that was used when the NC programs was generated in <strong>CNC</strong>-<strong>Calc</strong>. Now exit the configuration dialog with OK.
66 After the tools have been configured, the screen should look like the one below. Try to find the tool changes and verify that the tool does endeed change when a tool change is encountered in the NC program.
Page 1 and 2: www.cimco-software.com CIMCO CNC-Ca
Page 3 and 4: 28 9.1. Before you start The first
Page 5 and 6: 30 9.2. Draw the geometry Draw a re
Page 7 and 8: 32 Create a fillet between elements
Page 9 and 10: 34 Connect the inner elements Activ
Page 13 and 14: 38 10.2. Creation of Facing toolpat
Page 15 and 16: 40 Now close the parameters dialog
Page 17 and 18: 42 The line for the NC program is n
Page 21 and 22: 46 11.2. Creation of Contour toolpa
Page 23 and 24: 48 Side cuts are the cuts taken in
Page 25 and 26: 50 Lead in/out parameters describe
Page 27 and 28: 52 Click on Export Clipboard to cop
Page 31 and 32: 56 12.2. Creation of Pocket toolpat
Page 33 and 34: 58 At All Depths: If this check box
Page 35 and 36: 60 Lead in/out parameters describe
Page 37 and 38: 62 13. Tutorial 5 Backplot in the E
Page 39: 64 13.2. The first backplot When yo
Page 43 and 44: 68 Now everything has been configur
Page 45 and 46: 70 Select the file from CNC-Calc Ca
Page 47 and 48: 72 For the selection of the locatio
Page 49 and 50: 74 Once the toolbars have been sele
Page 51 and 52: 76 Select the feature Letter Millin
Page 53 and 54: 78 To verify the generated toolpath
Page 55 and 56: 80 16. Tutorial 8 Milling of TrueTy
Page 57 and 58: 82 In the bottom field you write th
Page 59 and 60: 84 The Letter Milling dialog has no
Page 61 and 62: 86 16.2. Pocket milling letters The
Page 63: 88 Verifying the toolpaths using th

CIMCO CNC-Calc v2.5 User Guide

Create successful ePaper yourself

Delete template?

Save as template?