CIMCO CNC-Calc v2.5 User Guide

86
16.2. Pocket milling letters
The toolpath generated from the text look like a contour operation formed by the
outlines of the letters and numbers. The area inside these contours - inside the letters
- can be milled like a special pocket milling operation. The rest of this tutorial will
show you how to do this.
1. Return to the drawing by clicking the tab marked A in Figure 9.11 below.
2. Click on the button New marked B, and select the letters for the operation.
3. Click the button Parameters marked C.
4. Insert the new parameters as shown below (remember to check the 5. checkbox
Mill Interior).