Classical & Heritage lighting - Indal

Villa
versions & Dimensions
765
440
760
440
VILLA
VILLA
IJT
IJT-S
VILLA
VILLA
IJT
IJT-S
All Villa versions are available with RETROLED technology (IJY).
> RETROLED technology on p. 264
MATERIALS
crown
bowl
frog
765
440
- Housing in gravity die-cast aluminium.
- Bowl in polymethacrylate (PMMA).
760
Conventional sources
- Control gear mounting plate in galvanised steel.
- Reflector in bright dipped anodised stamped aluminium.
- Luminaire gasket in EPDM.
(without bowl)
- Control gear mounting plate in aluminium sheet.
- Housing of RETROLED engine in extruded aluminium.
- Lenses in PMMA.
- Optic gasket in EPDM foam.
440
canopy
frame
FINISHES
- Aluminium and stainless steel: polyester powder coating finish in RAL or
Futura Akzo Nobel colours. RETROLED engine in textured black.
- Clear or opal bowl.
> Materials & finishes on p. 206
RECYCLING
The housing of the luminaire (excluding the optical unit) is assembled
without glue, which makes recycling easier.
MOUNTING
- Top mounting star type for threaded spigot Ø 34 pdg (1’’ G).
- Post top mounting for column top Ø 60mm using adapting piece
AS Ø 60mm.
- Post top mounting for column top Ø 76mm using adapting piece
AS Ø 76mm.
- Suspended mounting using a threaded spigot in galvanised steel
Ø 34 pdg (1’’ G).
> Luminaire mounting on p. 269
Installation & maintenance
- Luminaire opening without tools, by using one M5 12 screw located on
the canopy.The luminaire is opened by tilting the canopy in the post top
version or the frame in the suspended version.
- Luminaire maintains in open position by means of a telescopic slider with
automatic unlocking.
- Lamp access without tools, after opening the luminaire by unlocking the
leaf spring.
Conventional sources
- Electrical connection by terminal strip for a flexible power cable with
3G 2.5 maximum cross-sectional area.
- Control gear access without tools, after opening the luminaire.
- Optical unit replacement directly after opening the luminaire.
- Electrical connection by a traditional Wieland three pin-connector for
a flexible power cable with a cross-sectional area of 2 x 1,5 or 3G 1,5.
- LED engine access after opening the luminaire, by unlocking the
RETROLED engine using four M4 Torx screws. Mounting plate removed
manually using one clip.
- LED engine replacement possible on location.
Classical & Heritage • page 260