this SIM5218 AT command manual - Cooking Hacks

SIM5218 Serial AT Command Set
AT+CLIR=
+CLIR:(0-2)
OK
9.7 AT+COLP Connected line identification presentation
Description
The command refers to the GSM/UMTS supplementary service COLP(Connected Line
Identification Presentation) that enables a calling subscriber to get the connected line identity
(COL) of the called party after setting up a mobile originated call. The command enables or
disables the presentation of the COL at the TE. It has no effect on the execution of the
supplementary service COLR in the network.
When enabled (and called subscriber allows), +COLP:, [,,
[,]] intermediate result code is returned from TA to TE before any +CR responses.
When the AT+COLP=1 is set, any data input immediately after the launching of “ATDXXX;” will
stop the execution of the ATD command, which may cancel the establishing of the call.
SIM PIN References
YES 3GPP TS 27.007
Syntax
Test Command
AT+COLP=
Read Command
AT+COLP
Responses
+COLP: (list of supported s)
OK
Responses
+COLP: ,
OK
ERROR
+CME ERROR:
Write Command
AT+COLP =
Execution Command
AT+COLP
Responses
OK
ERROR
+CME ERROR:
Responses
Set default value(=0, =0):
OK
Defined values
SIM5218_Serial _ATC_V1.36 155
5/15/2012